Sump Pump Installation in North York

Does your house need one?

A sump pump earns its place in homes where weeping tiles collect water around the foundation, especially after those tiles are disconnected from the sanitary sewer. It also helps basements that sit close to a high water table or on clay that stays saturated after spring thaw.

• Weeping tiles being disconnected from the sewer
• Damp floors or seepage after rain or snowmelt
• An old, broken or undersized pump already in place
• A basement being finished, where a dry floor matters more

What installation involves

1. Locate the pit. Usually near the point where weeping tiles can be connected, often a front or side corner.
2. Cut and dig. The floor is cut, a liner is set and tiles are connected.
3. Fit the pump. A submersible pump with a reliable float switch is installed with a check valve.
4. Discharge. Pipe exits through the wall to ground that carries water away from your house and the neighbours’.
5. Power and test. A dedicated outlet and a full fill-and-empty test finish the job.

Choosing the pump

Pump capacity should match how much water reaches the pit. A cast-iron submersible with a vertical float suits most North York houses. A sealed lid cuts noise and humidity, and helps keep debris out. Where outages are a concern, add a battery backup.

Toronto subsidies

Toronto’s basement flooding subsidy has in the past included sump pumps when paired with foundation drain disconnection. Confirm the current rules before work begins. See basement flooding protection for how the pieces fit together.